Firmware
Carina Phase Two:
- Carina GaN, Carina 300 and Carina 150 firmware: Instructions and download link
Nova500, Nova300, Nova150:
- nova500 Firmware Release 2.0 Instructions and download link
- nova150 Firmware Release 1.9 Instructions and download link
- nova300 Firmware Release 1.9 Instructions and download link
NOTE: Firmware 1.9 is for use ONLY with nova150/300 with a WiFi button on the front panel. If your nova does not have a WiFi button, DO NOT USE.
USB Drivers
USB audio not working after Windows 10 update?
If you are experiencing problems with USB audio on one of these Peachtree products, please re-install the Peachtree USB X audio driver.- DAC•iT X (purchased October 2014 or earlier)
- X1 USB to SPDIF Converter (purchased April 2015 or earlier)
- Grand Integrated X-1
Re-install ONLY if you are using one of the above Peachtree Audio products. Instructions for Re-installing Peachtree X Driver in Windows 10
IMPORTANT! You must remove all Peachtree files from your computer's Control Panel before re-installing the Peachtree X driver.
WINDOWS USB DRIVER INSTALLATION
To play back music files from a Windows PC on your Carina, preDAC, nova500, nova300, nova150, sonaDAC or shift download and install Peachtree USB audio driver
Note: Do not connect the Carina, preDAC, nova500, nova300, nova150, sonaDAC or shift to your computer until the installer asks for it to be plugged in and switched on.
THESE MODELS ONLY
- DAC•iT X (purchased November 2014 or later)
- X1 USB to SPDIF Converter (purchased May 2015 or later)
Here are instructions and download links for installing Peachtree Audio 24/192 USB audio drivers for Windows 10, Windows 8 and Windows 7. These drivers should be installed before streaming audio via your Windows PC's USB connection to the llisted Peachtree components ONLY.
IMPORTANT: Before installing driver be sure that the switch on the rear panel of your amplifier is set to the 192K position (push the switch “in”). The installation will fail if it is set to the 96K (“out”) position. (Does not apply to DAC•iT X and X1)
Click here: Peachtree Windows Driver Instructions - SE
Download driver here: Peachtree 24/192 USB X SE audio driver
OTHER PEACHTREE MODELS
- DAC•iT X (purchased October 2014 or earlier)
- X1 USB to SPDIF Converter (purchased April 2015 or earlier)
Click here: Peachtree Windows Driver Instructions
Download driver here: Peachtree 24/192 USB X audio driver
If you have any other Peachtree Audio integrated amp or DAC, these drivers are unnecessary and should NOT be installed.
ADDITIONAL USB DRIVER INFORMATION
Not sure whether you need to install a USB audio driver on your computer for best performance from your Peachtree component?
Consult this handy chart:
PEACHTREE MODEL | COMPUTER OPERATING SYSTEM | |
---|---|---|
WINDOWS 10, WINDOWS 8, WINDOWS 7 | MAC OS X (ALL VERSIONS) | |
|
Peachtree Windows Driver Instructions - SE Peachtree 24/192 USB X SE audio driver |
no driver required |
|
Peachtree Windows Driver Instructions Peachtree 24/192 USB X audio driver |
no driver required |
|
To receive instructions and driver email us with:
|
To receive instructions and driver email us with:
|
|
no driver required | no driver required |
Please feel free to contact us for further assistance:
service@peachtreeaudio.com
704-391-9337 Mon-Fri 12PM-6PM Eastern time